Tooling and threaded pin update

Hi everyone,

Just a quick update to keep everyone in the loop as to where we are at. The tooling  for the main tool body is currently still being made. The tooling for the injection moulding for the nylon over mould for the tyre lever is now complete.

We have now fully resolved and signed off the threaded pin for the chain breaker. As you can see from the pictures below we have beefed up the thread from a M6 thread (bottom) too a M8 thread (top) and also added a chamfer to increase the pins end strength. We have tested it thoroughly and are really happy with it.

Cheers

Mark